2.25 inch diameter Wood Disc with at least 12mm hole
Keychain Split Ring
11mm Jump Rings - 3
Want2Scrap: Say It With Bling: Allure Swirl – Silver
Small Flat Bristle Brushes - 2
Sectioned Paint Tray
Drop a few drops of each of the 2 colors of IZINK into separate sections of the paint tray.
Dab one of the paintbrushes into Volubilis, but do not saturate brush with ink, and brush the color onto the top and bottom of the wood disc leaving the center area open. Brush the IZINK until there is no ink on brush and it is fairly dry. If ink is not dry within 30 to 60 seconds, blot ink with paper towel.
Repeat step 2 with Cactus IZINK.
Create a blended effect by overlapping the colors where they meet. Repeat steps 2 thru 4 on back.
Paint edge of disc with either color; blot with paper towel or let dry.
Ink Patched Molding Mat using Imperial Archival Dye Ink. Using corner of mat, stamp 3 triangular designs of varying size around the edge on front side of wood disc. On back, stamp a small triangular shape around the outside edge, again using the corner of the mat.
Make sure disc is completely dry. Cut bling apart and apply to embellish both sides as shown.
Hook one of the jump rings through the hole in wood disc and pinch close with pliers. Hook another ring to the split ring and pinch closed. Use the third jump ring to connect the other two together and pinch closed.